Cue-Sampler Dual Mode; Loop-Sampler Dual Mode - Reloop RP8000 Operation Manual

Cue-Sampler Dual mode

Press both the CUE and SAMPLER mode buttons to set the
PADs to HotCue-Sampler dual mode (both leds will turn
on)
In this mode the 4 upper Pads trigger HotCues 1 to 4 and
the 4 lower Pads trigger a sample (1 to 4) from the selected
Sampler Bank.
Hold* the CUE mode button down and then use the 4 upper
Pads to delete their assigned HotCues.
Hold* the SAMPLER mode button down and then press any
of the 4 lower pads to stop the playing sample (useful when
the unmute or stutter mode is selected)
Hold* the SAMPLE button down and then use the TRAX
encoder (9) to adjust the Master Volume of the Sampler.
*
If no Pad is pressed while the mode buttons are pressed, the CUE
or SAMPLER single mode will be selected once the mode button is
released.

Loop-Sampler Dual mode

Press both the LOOP and SAMPLER mode buttons to set
the PADs to Loop-Sampler dual mode (both leds will turn
on)
In this mode the 4 upper Pads trigger a Loop (1/8 to 1 beat)
or a momentary Loop Roll (1/36 to 1/4 beats) of a different
size and the 4 lower Pads trigger a sample (1 to 4) from the
selected Sampler Bank.
To trigger a Loop Roll, press the LOOP mode button (led will
blink) and then use the lower Pads.
While a Loop is triggered, hold the LOOP mode button down
and then use the TRAX encoder (9) to move the loop
forward or backwards by half the size of the triggered loop
Hold* the SAMPLER mode button down and then press any
of the 4 lower pads to stop the playing sample (useful when
the unmute or stutter mode is selected)
Hold* the SAMPLE button down and then use the TRAX
encoder (9) to adjust the Master Volume of the Sampler.
VirtualDJ 8 – Reloop RP8000
11