Rear Connections - Reloop RP8000 Operation Manual

*
If no Pad is pressed while the mode buttons are pressed, the CUE
or SAMPLER single mode will be selected once the mode button is
released.
Note: The Dual modes can be disabled-enabled by following this procedure:
- Power off the unit.
- While holding both the SAMPLER mode button and the TRAX encoder (9) down,
power on the unit.
- Use PAD Nr.2 to enable/disable the Dual mode (On when enabled - Off when
disabled).
- Push the TRAX encoder to save setting
C. Rear connections
12. AUDIO OUTPUT. Use the provided (or any standard) RCA cables to connect the RP-
8000 with the Line/Phono Inputs of your DVS sound card or mixer.
13. PH/LN. Switch to LN position in case your sound card or mixer, do not offer any
Phono Inputs.
14. USB. Use this socket to connect your Master (primary) turntable with the computer or
connect any Slave unit to the TT LINK socket of the Master unit.
15. TT LINK. Use this socket to connect a Slave Player
16. AC IN. Use the provided AC cable to power the unit.
VirtualDJ 8 – Reloop RP8000
12