Slicer Mode; Cue-Loop Dual Mode - Reloop RP8000 Operation Manual

Slicer mode

Press the SLICER mode button to set the PADs to Slicer
mode.
The 8 pads represent 8 sequential beats—"Slices"—in the Beat
Grid. The playing Slice is represented by the currently lit pad.
The light will "move through the pads" as it progresses through
each 8-Slice phrase. Press a pad to repeat that Slice (hold it
down if you want to keep looping it).
Once the Pad is released the track will continue to play from
the position it would have been if the pad was never pressed.
While in Slicer mode, press the SLICER mode button again to
set the PADs to Slicer Hold mode.(Led will blink)
In this mode the pads offer the same functionality as in the
Slicer mode, but in this case, the Slice is memorized on first
press as the track continues to play. (HOLD mode).
The unlit Pad will indicate the currently playing Slice.
Hold the SLICER mode button down and then use Pads 1 and
2 to increase/decrease the length of the applied loop on the
slice.
Hold the SLICER mode button down and then use Pads 7 and
8 to increase/decrease the step (size) of the slice.

Cue-Loop Dual mode

Press both the CUE and LOOP mode buttons to set the PADs
to HotCue-Loop dual mode (both leds will turn on)
In this mode the 4 upper Pads trigger HotCues 1 to 4 and the
4 lower Pads trigger Loops (1/8 beats to 1 beat in size) or
momentary Loop Rolls (from 1/32 to ¼ beats).
Hold* the CUE button down and then use the 4 upper Pads to
delete their assigned HotCues.
To trigger a Loop Roll, press the LOOP mode button (led will
blink) and then use the lower Pads.
While a Loop is triggered, hold the LOOP mode button down
and then use the TRAX encoder (9) to move the loop forward
or backwards by half the size of the triggered loop
*
If no Pad is pressed while the mode buttons are pressed, the CUE
or SAMPLER single mode will be selected once the mode button is
released.
VirtualDJ 8 – Reloop RP8000
10