Connecting Cables - Avigilon ENC-4P-H264 Installation Manual

The encoder can be attached to the bracket by lining up the four holes
on the bottom of the encoder with the hole pattern on the bracket and
screwing them together with the screws provided with the bracket.
Warning —
•
•
•

Connecting Cables

Refer to the diagrams in the Overview section for the location of the
different connectors.
To connect the cables required for proper operation, complete the
following:
1. If there are external input or output devices that need to be
connected to the encoder (for example: door contacts,
relays, etc), connect the devices to the encoder I/O
Terminals.
For more information, see Connecting to External Devices.
2. If external microphones or speakers need to be connected
to the encoder, connect the devices to the encoder's audio
connectors. For more information, see Connecting
Microphones and Speakers.
3. Connect the Ethernet Port (RJ45 connector) to a network
using an Ethernet network cable. The Link LED will turn on
once a network link has been established.
4. Connect power using one of the following methods:
4
If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of
the rack environment may be greater than room
ambient. Ensure that the ambient temperature
inside the rack does not exceed the maximum
operating temperature of the encoder.
Ensure that sufficient airflow is provided in the
rack environment such that safe operation of the
equipment is not compromised.
Mounting of the equipment in the rack should be
such that a hazardous condition is not created
due to uneven mechanical loading.