Operation; Starting A Wash Cycle; Changing A Programme; At The End Of A Programme - Currys Essentials CDW60W13 Instruction Manual

Operation

Starting a Wash Cycle

1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets back. It is
recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not
slam the door.
5. Press the On/Off button. The Power indicator will light up.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the
section Wash Cycle Table.
7. The programme indicator will light up for the selected programme.
8. Press the Start/Pause button, the washing cycle will begin shortly and the programme indicator will
flash.
If you open the dishwasher's door during the washing cycle and then close it, the dishwasher will continue the
current washing programme after 10 seconds.

Changing a Programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the dishwasher door, press the Start/Pause
button then press and hold down the Program button for 3 seconds to cancel the programme. The
programme indicator will light up solidly. You can then select the required new programme. Press the
Start/Pause button. The unit will start the new washing cycle shortly and the new programme
indicator will flash.

At the End of a Programme

At the end of a programme, the dishwasher will beep.
The condensation strip helps to prevent the risk of steam damage to the worktop edging above the dishwasher,
it is advisable to leave the door closed until you are ready to unload the crockery. However, you can also open
the dishwasher door fully and wait until the dishes and crockery are cool enough to unload. Do not leave the
door only partially open.
25