Currys Essentials CDW60W13 Instruction Manual page 11

INSTALLATION
6. Position the dishwasher next to a water tap and
a drain. Ensure the water inlet and drain hoses
are not kinked or squashed. The unit must not
stand on the mains cable.
7. Make sure your plumbing is suitable for use with
the dishwasher. If in doubt contact a qualified
plumber. This unit MUST BE connected to COLD
WATER MAINS using the new water inlet hose.
OLD HOSE SETS MUST NOT BE RE-USED. The
water pressure from the water mains needs to
be at a minimum of 0.04 MPa and a maximum of
1.00MPa.
• Connect one end of the safety water supply
hose to your dishwasher, and then connect
the other end of the hose to your water
mains. Please ensure the black rubber seal is
in place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
You may use a Y-adaptor (not included) for an
additional water feed for another appliance,
for example a washing machine. This is only
applicable for cold water mains. A Y-adaptor
is available from most DIY stores.
• Do not bend your drain hose.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance if
required.
safety water supply hose
11