Condition 2: "TARE" function
When LCD reading is >1g,
LCD will show "-----" or "0g" each time "
Z/T"
is touched.
"-----" means not stable, please wait for a moment. "0g"
and meanwhile an icon "TARE" on upper left corner of
LCD mean "TARE" function is active. Max. capacity is
reduced by total weight of all loads.
TO SET ALARM TIMER
Touch
Touch T-SET
"
"
to begin a l a r m
"T-SET"
t i m e r s e t t i n g
Touch "ON/OFF"
Setting 1st binary digit
Setting 2nd binary digit
to switch on
for minutes
for minutes
Touch
"T-SET"
Touch
"T-SET"
Touch "T-SET" to start
Setting 2nd binary digit
Setting 1st binary digit
count down
for seconds
for seconds
1. When setting time span, touch "T-SET" to confirm and prompt to next digit. After
setting time span, touch "T-SET" to start counting down. During counting down,
touch "T-SET" to clear the set time span.
2. The timer counts down to "00:00", alarm will start "beeping" for 60 times and
scale
will
switch off automatically
3. Touch any key to stop "beeping".
4. Max. time span of the alarm timer: 99:59.
5
TEMPERATURE SENSOR
o
1. Temperature range: 0~+40 C
Temperature
display
2. Division: 0.5 C
o
AUTO SHUT OFF
Auto shut-off occurs if display shows
g
'0' or shows the same weight reading
for 2 minutes.
MANUAL SHUT OFF
To maximize battery life,
always touch
"ON/OFF" again to turn off the scale
after using.
WARNING INDICATORS
1.
1. Replace new battery.
2. Scale overload. Remove item to avoid damage.
2.
Max.Weight capacity is indicated on the scale.
6
CLEANING AND CARE
1. Clean the scale with a slightly damp cloth. DO NOT immerse the scale in water
or use chemical/abrasive cleaning agents.
2. All plastic parts should be cleaned immediately after contact with fats, spices,
vinegar and strongly flavored/colored foods. Avoid contact with acids citrus juices.
3. Always use the scale on a hard, flat surface. DO NOT use on carpet.
05EK-016E R1
7
Electronic Kitchen Scale with Touch Button
INSTRUCTIONS FOR USE
ISO 9001:2000 CERTIFIED BY SGS
EK-9 SERIES