Sony XTL-W7000 Service Manual page 10

XTL-W7000
2 Connect the grounding cable from the TV antenna
amplifier unit to a metal part of the car body where it can
make a good ground contact.
3 Connect the antenna input cables to the TV antenna
amplifier unit according to the markings on the amplifier
(1, 2, 3, 4, TV).
7
Connect the TV main unit and the car's ACC power
supply.
1 Connect the antenna terminal (L-type) on the TV antenna
amplifier unit qd to the TV main unit.
2 Connect the accessory power supply terminal to the car's
ACC power supply.
• Connect the ACC power supply cord from the TV main
unit to the spare contact.
• Do not connect directly to the battery.
8
Replace the front pillar molding.
9
Fasten cords out of the way.
Front pillar
Antenna
input
cable
(left) qg
4 After Installation and Connections
1
Start the car's engine.
2
Verify that the brake lights, other lights, horn, turn
indicators, and all other electrical parts operate
normally.
Note
To avoid the possibility of damage, you
3
Use a ball-point pen or similar to push the Reset
should not use a needle or push the
button on the unit.
button too strongly.
When you press the Reset button, the system becomes
operative.
10
Antenna contacts
Spare contact
Ground contact
Vehicle ACC power supply
Film antenna Film antenna
(left) qf (right) qf Front pillar
Antenna
input
TV
cable
(right) qg
TV antenna
amplifier unit qd
21
Reset button
23
Changing the transmitted frequency on
ENTER
MUTING TV/VIDEO
the TV unit
OFF
CH+
MENU
MENU
–
SEEK SEEK+
You can change the transmitted frequency on the built-in RF
V/v
ENTER
–
CH modulator of the TV unit. The default setting is "88.3MHz".
BACK
BACK
WIDE PICTURE DSPL
1
Press MENU.
1 2 3
2 Press V or v to select
4 5 6
7 8 9 VOL
3 Press V or v to select "RF FREQUENCY", then press
10 11 12
ENTER.
4
Press V or v to adjust the transmitted frequency.
Adjust the frequency range from "88.3MHz" to "89.9MHz".
5
Press ENTER.
6
Press MENU.
Changing the output level on the TV unit
You can change the output level of the TV unit according to the
input level of the FM tuner of a car audio. The default setting is
"MID".
1
Press MENU.
2
Press V or v to select
3 Press V or v to select "RF LEVEL", then press ENTER.
4
Press V or v to select the output level.
You can select from "HIGH", "MID" or "LOW".
5
Press ENTER.
6
Press MENU.
22
, then press ENTER.
, then press ENTER.