Honda NT700V Owner's Manual page 214

Hazard Switch (3)
This system should be used only when your
motorcycle is stopped under emergency
or hazardous conditions. To turn it on, turn
the ignition key to the ON position, and
then slide the switch marked
and rear turn signals will blink simultaneously.
All of the turn signals can blink without the
ignition key.
To operate this function, proceed as
follows:
1. Turn the ignition key to ON position and
then slide the hazard switch to the
marked position.
2. All of the turn signals will keep blinking
even after you turn the ignition key to
OFF position.
3. You can turn off the turn blinking signals
by sliding the hazard switch back to the
off position.
If the switch is left in the off position for
more than two seconds, and then
54
Be sure to turn the switch off when the
hazard warning is no longer required, or
. The front the turn signals will not work properly, and
may confuse other drivers.
If all the turn signals are left blinking with
the engine stopped, the battery will be
discharged.
(3) Hazard switch
moved back to the
the turn signals will not be on.
position again,
E