Booster To Harness Mode - Britax Frontier XT SICT User Manual

Switching Between Modes
Turn and slide the retainer through the slot to remove.
6
* Pull the harness webbing tight
from the other side before
pulling the retainer through.
Repeat steps 5 and 6 for the
7
remaining harness buckle
strap.
Remove the locking screw
8
from the head restraint
adjuster and insert into the
shell to store.
IMPORTANT: Store the screw in
the slot provided in the shell. Store
all parts of the harness in a safe
place. These parts will be needed
to convert the child seat back to
harness mode.
Booster.to.Harness.Mode
To.replace.the.harness.and.
buckle:
Move the harness adjuster to
1
the highest position (a), then
move the head restraint to the
lowest position (b).
* Ensure that harness slots in
the cover, head restraint and
harness adjuster are aligned.
Replace the locking screw
2
to lock the head restraint
adjuster.
Turn and slide the retainer of
3
the buckle strap through the
buckle slot.
* Choose the slot that is closest
to, but not under your child.
Slide the retainer back into
4
place to hold it against the
child seat shell. Verify that the
strap is not twisted, and that
the button faces out.
32
Locking.
Screw.storage
Locking.
Screw.storage
Turn and slide the retainer of
5
each harness strap through
the harness slot.
* Ensure that the icon on the
chest clip faces out.
Slide each retainer back into
6
place on the child seat shell.
Insert the harness straps
7
through the slots in the cover,
shell, and harness adjuster to
the back of the child seat.
Remove the harness yoke
8
from storage on the belt shield
(a), then remove the belt
shield (b).
Nest the harness straps by
9
inserting the right strap loop
into the left strap loop.
Before reattaching the harness
10
straps, hold the harness yoke
as shown, and ensure that the
adjuster strap attached to the
yoke is not twisted.
Slide nested harness straps
11
completely onto the harness
yoke.
Switching Between Modes
Adjuster
Strap
33