Setting Up The Answering Machine - Sony TAM-100 Service Manual

QQ
3 7 63 1515 0
New type: Serial number 4,000,001 and later

Setting up the answering machine

Connect the answering machine
1
Telephone line cord
(supplied)
To TEL
To AC outlet
3
AC power adaptor
(supplied AC-T70)
1
Unplug the telephone line cord from your telephone and connect the
telephone line cord (supplied) to the TEL jack of the answering
machine and to the telephone.
2
Connect the telephone line cord to the LINE jack of the answering
machine.
3
Connect the AC power adaptor to the DC IN 12V jack of the
answering machine and to an AC outlet.
"P" flashes in the display window.
Notes
• Use only the supplied AC-T70 AC power adaptor. Do not use
any other AC power adaptor.
• Connect the AC power adaptor to a continuous power supply.
TE
L 13942296513
• Place the answering machine close to the AC outlet so that you
can unplug the AC power adaptor easily.
Tip
If your telephone outlet is not modular, contact your telephone
service company for assistance.
Preparing the answering machine
Setting the day and time
Set the day and time so that you can stamp day and time for the incoming
messages. You'll hear the recorded day and time when you play back messages.
www
.
http://www.xiaoyu163.com
Hook the cord.
To telephone
outlet
To DC
To LINE
IN 12V
2
Telephone line cord
Polarity of the plug
–
Modular
1
Press (SET/REC).
2
Press (TIME).
You hear a voice guide: "Please set
the day. To select, press the SKIP or
REPEAT button. To enter, press the
SET button".
3
Press (SKIP/QUICK) or
(REPEAT/SLOW) repeatedly until the
correct day of the week is announced.
Press (SKIP/QUICK) to advance, or
(REPEAT/SLOW) to go back.
x ao
y
i
http://www.xiaoyu163.com
8
4
Press (SET/REC).
You hear a voice guide: "Please set the hour. To select, press the
SKIP or REPEAT button. To enter, press the SET button".
5
Press (SKIP/QUICK) or (REPEAT/SLOW) repeatedly until the correct
hour is announced.
6
Press (SET/REC).
You hear a voice guide: "Please set the minute. To select, press the
SKIP or REPEAT button. To enter, press the SET button".
7
Press (SKIP/QUICK) or (REPEAT/SLOW) repeatedly until the correct
minute is announced.
8
Press (SET/REC).
You hear a long confirmation beep, followed by the day and time.
Then the answering machine starts counting time.
Notes
• Do not allow more than 20 seconds (or 60 seconds when setting the minute) to elapse
between each step of the procedure.
• If a power interruption occurs, the day and time will be erased.
• If the current day and time are not set, you will not hear a time stamp when you play
back recorded messages. If you try to check the current time, you will hear five short
error beeps.
To check the current time
Press (TIME). You hear the current day and time.
Recording the greeting
This answering machine has prerecorded greetings. However, you can record
your own greeting.
The greeting must be between two seconds and four minutes long.
You can record a greeting for each of the answering mode ("normal" and
"announcement only" modes. See "Selecting the answering mode"). To record a
Q Q
+
3 6 7 1 3
greeting for the "announcement only" mode, select the mode first, then follow
the instructions below (see "Selecting the answering mode"). Otherwise, the
normal greeting will be recorded.
(ERASE)
MIC (Microphone)
Notes
• If recording did not succeed, you hear five short error beeps. Start over the procedure.
• If a call comes in while recording a greeting, recording is cancelled. Start over the
procedure.
• If you hear five short error beeps while recording, the recording area may be full. In this
case, erase unnecessary messages.
Tips
• If four minutes have passed in step 3, recording stops automatically.
• To record the greeting from a touch-tone phone, see "Operating from an outside phone".
• Even if a power interruption occurs, your own greeting is not erased.
• If your own greeting is recorded, the greeting has priority over the prerecorded greeting.
u163
.
– 5 –
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
1
Press (SET/REC).
2
Press (GREETING).
You hear a voice guide and a long
confirmation beep.
3
After the tone, start recording. Speak
about 12 inches (30 cm) away from
the microphone.
4
Press (SET/REC) to stop recording.
The answering machine
automatically replays the recorded
greeting.
m
co
Ver 1.1 2001.06
9 9
2 8 9 9