Abit IP35V User Manual page 42

[4 Pin]: Leave this item at its default [4 Pin] setting for connecting a 4-pin cooling fan to the
"CPUFAN1" fan power header.
[3 Pin]: For a 3-pin cooling fan connection, you must configure this item to [3 Pin] in order to
have the speed control function enabled.
A mismatched configuration will cause the fan speed control function out of
※
order. Please select the correct option according to your fan type.
- FanEQ Target Temp
This item sets the temperature mark for the "CPU FanEQ" function to take effect.
- FanEQ Temp. Tolerance
This item sets the temperature tolerance range for the item "FanEQ Target Temp.".
- FanEQ Start Control
This item sets the speed ratio for the CPU fan connected to "CPUFAN1" fan power header to
start running.
- FanEQ Stop Control
This item sets the lowest speed ratio for the CPU fan connected to "CPUFAN1" fan power
header to run at when the CPU temperature detected is lower than the value of item "FanEQ
Target Temp." plus the value of item "FanEQ Temp. Tolerance".
In the situation when the CPU temperature detected is higher than the value of item "FanEQ
Target Temp." plus the value of item "FanEQ Temp. Tolerance", the speed ratio for the CPU fan
connected to "CPUFAN1" fan power header will first run at the speed ratio set by the item
"FanEQ Start Control", and then up to 100%.
SYS FanEQ Control
When set to [Enabled], these items control the SYS fan speed by the following setting
combinations.
- FanEQ Reference Temp.
This item selects the reference point for taking temperature.
- FanEQ Target Temp
This item sets the temperature mark for the "SYS FanEQ" function to take effect.
- FanEQ Temp. Tolerance
This item sets the temperature tolerance range for the item "FanEQ Target Temp.".
- FanEQ Start Control
This item sets the speed ratio for the CPU fan connected to "SYSFAN1" fan power header to
start running.
- FanEQ Stop Control
This item sets the lowest speed ratio for the CPU fan connected to "SYSFAN1" fan power
header to run at when the CPU temperature detected is lower than the value of item "FanEQ
Target Temp." plus the value of item "FanEQ Temp. Tolerance".
2-20 IP35V