Table of Contents
Advertisement
ENGLISH (Original instructions)
SPECIFICATIONS
Capacities
-1
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
Noise
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB(A)
Wear ear protection
Model
Steel
Wood
Wood screw
Machine screw
High
)
Low
Overall length
Net weight
Rated voltage
equipment
and
environmentally
compatible
) : 70 dB(A) or less
pA
END004-2
Vibration
The
vibration
determined according to EN60745:
Work mode: Drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
its
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENE034-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG103-2
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
EC Declaration of Conformity
We
Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine: Cordless Driver Drill
Model No./ Type: 6096D
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2
6096D
10 mm
18 mm
5.5 mm x 55 mm
6 mm
0 - 1,100
0 - 350
210 mm
1.2 kg
D.C. 9.6 V
total
value
(tri-axial
) : 2.5 m/s
h,D
2
Corporation
as
the
ENG202-3
vector
sum)
2
or less
ENG901-1
ENH101-12
responsible
Advertisement
Table of Contents
