Method Of Software Upgrading - Sanyo LCD-32XR56DZ Service Manual

3.6 HDMI port
Input HDMI signal from signal generator VG-849 with the formats as Table 4 and Table 5
respectively, check if the display and the sound（32 KHz、44.1 KHz、48 KHz）are normal under
the circumstances of power-on/off, switching channel, switching signal format, etc.
3.7 Other functions check
a) Check if the functions are normal —timing turn-on/off 、 turn-off
picture/sound mode、OSD、stereo and digital audio interface, etc.;
b) Check if audio only digital programs (RADIO) are normal;
c) For UK models, check if MHEG function of digital programs are normal;
d) Check if common interface（CI：Common Interface）is normal;
e) For New Zealand models, check if function of logic channel number (LCN) is normal, check
if function of Over Air Download（OAD）is normal;
f) For France, UK and Italy models, check if function of logic channel number (LCN) is
normal.
4 User menu setup before leaving factory
Enter into page "LOCK" of user menu, select submenu item "Restore Factory Default" to preset
items before leaving factory as below:
a) Clear out all programs information;
b) Clear out information of parental control (VCHIP);
c) Default setup of user analog data;
d) Set Menu Language as English;
e) Set Power on MODE as Off.
Instruction of factory software burning as Table 6
5
No. Part No.
N111 5276405001
N108 5272404002
NA04 5272402002
NA05 5272402002
NA06 5272402002
N106 5272402002
Note 1: Write-protect setup method
Enter into burning interface of
Setting", set item "Protect" as "All Protect"; be sure to select item "Config" before burning
software, and write-protect must be re-set after burning program ALL-100 startup every time.
Table 6 Instruction of factory software burning
Part type
MX25L6405DMI-12G
AT24C04
AT24C02
AT24C02
AT24C02
AT24C02
program
Instruction of Burned
software before
function SMT
FLASH Yes
HDMI KEY Yes
HDMI EDID Yes
HDMI EDID Yes
HDMI EDID
(supporting Yes
the3rd HDMI)
VGA EDID Yes
ALL-100, select item "Config", press item "config
of sleeping time 、
Burning method
burned with program
ALL100, write-protect setup,
refer to Note 1 in detail
burned with program ALL100
burned with program ALL100
burned with program ALL100
burned with program ALL100
burned with program ALL100