Method Of Software Upgrading Instructions - Sanyo LCD-40XR10F Service Manual

Method of software upgrading instructions

Factory software burned instructions listed as Table 5
No. Part No.
N803 5276405001
N804 5272404002
NA04 5272402002
NA05 5272402002
NA06 5272402002
N106 5272402002
Note 1: Method of write-protect setup: enter into burning interface of ALL-100, tick option "Config",
press item "config Setting", set option "Protect" as "All Protect"; make sure that option
"Config" must be ticked before burning software and write-protect must be reset after
ALL-100 burning software opened every time.
Note 2: Method of burning and upgrading software by using ISP burning device:
1） For main board upgrade: Connect the cable of ISP burning device to Debug port (X107) of main
board; for TV set upgrade, connect both VGA ports of ISP burning device and main board, enter
into factory menu and set item "ISP Mode" as "ON";
2） Using Mstar online burning program (V4.4.2.0 or higher versions), enter into menu "Device", tick
option "WP Pin pull to high during ISP" to ensure that hardware write-protect of Flash is
removed and erasing process is normal, please refer to Fig. 2;
Table 5 Factory software burned instructions
Part Type
MX25L6405DMI-12G FLASH
AT24C04 HDCP KEY
AT24C02 HDMI EDID
AT24C02 HDMI EDID
HDMI EDID (for
example,
AT24C02 supporting the
third
HDMI)
AT24C02 VGA EDID
Fig. 2 Write-protect setup
Software Burned
function before SMT
Yes
Yes
Yes
Yes
Yes
channel
Yes
Burning method
Use ALL11 with write-protect, refer
to Note 1 in detail.
ALL11
ALL11
ALL11
ALL11
ALL11