The Ihealth System Care And Maintenance - iHealth BG1 Owner's Manual

THE IHEALTH SYSTEM CARE AND MAINTENANCE

Replacing the battery
Your meter comes with one 3V CR1620 lithium battery installed. The battery lasts up to six
months depending on the usage. Follow the instructions below to replace the battery.
1. Turn the meter over with the iHealth logo facing down.
2. Lift off the back cover by pulling firmly from the notch next to the test strip port.
3. Remove the battery by pressing the small white eject button next to the battery tray.
4. Insert the new battery with the "+" side facing up and snap it into place.
5. Press the back panel back in place by inserting the front clip into place and snapping the back
of the cover down.
When the "Battery is low" indicator appears within the app, replace the battery to ensure
successful and accurate measurements.
Disposal – Electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling advice.
Cleaning And Disinfecting the Meter and Lancing Device
The cleaning and disinfection is absolutely necessary for the test procedure, because cleaning
can ensure the meter works well (for example, display will be clear to see after cleaning); and
disinfection will reduce the chance of spreading infection to others.
The meter and lancing device should be cleaned and disinfected following each use. We suggest
that you use CaviWipes™ (Metrex® Research Corporation, EPA Reg. No. 46781-8, EPA Est. No.
Push
9