Table of Contents
Advertisement
2.4.6.1 Point-to-Point Configuration
When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the SIP Configuration page
2. Type the IP address of the remote device that you want to contact into the Dial out Extension
Note
CyberData Corporation
parameter is not selected.
field
Establishing point-to-point SIP calls may not work with all phones.
Figure 2-13. SIP Configuration Page Set to Point-to-Point Mode
Device is set to NOT register with a SIP server
(Figure
2-13), make sure that the Register with a SIP Server
930427L
Setting Up the V3 Paging Server
Configure the SIP Parameters
Operations Guide
29
Advertisement
Table of Contents
Need help?
Do you have a question about the VoIP V3 Paging Server and is the answer not in the manual?
Questions and answers