Installing The Water Line - GE PFE28 Owner's Manual And Installation Instructions

Ge bottom freezer refrigerator owner's manual and installation instructions
Table of Contents

Advertisement

Available languages

Available languages

INSTALLING
Installation
Instructions
THE WATERLINE (cont,)
D FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to the cold water pipe
with the pipe clamp.
Pipe Clam
Saddle-Type
Shutoff Valve
-- Vertical Cold Water
Pipe
NOTE: Commonwealth
of Massachusetts
Plumbing Codes 248CMR shall be adhered to.
Saddle valves are illegal and use is not permitted
in Massachusetts.
Consult with your licensed
plumber.
[_ TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing
washer begins to swell.
NOTE: Do not over tighten or you may crush
the tubing.
Pipe Clam_
Washer
Inlet End
Clam
Screw
D ROUTE THE TUBING
Route the tubing between the cold water line
and the refrigerator.
Route the tubing through
a hole drilled in the
wall or floor (behind the refrigerator
or adjacent
base cabinet) as close to the wall as possible.
[TICONNECT THE TUBING TO THE VALVE
Place the compression
nut and ferrule (sleeve)
for copper tubing onto the end of the tubing
and connect
it to the shutoff valve.
Make sure the tubing is fully inserted into
the valve. Tighten the compression
nut securely.
For plastic tubing from a GE SmartConnect
rM
Refrigerator
Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression
nut until it is hand tight, then
tighten one additional
turn with a wrench. Over
tightening
may cause leaks.
Saddle-Type
Shutoff Valve
PackingNut
Outlet Valve
Compression
Nut
/
SmartConnect
'M
_Tubing
Ferrule (sleeve)
NOTE: Commonwealth
of Massachusetts
Plumbing Codes 248CMR shall be adhered to.
Saddle valves are illegal and use is not permitted
in Massachusetts.
Consult with your licensed
plumber.
E] FLUSH OUT THE TUBING
Turn the main water supply on and flush out
the tubing until the water is clear,
Shut the water off at the water valve after about
one quart (1 liter or 2 minutes) of water has been
flushed through
the tubing.
To complete the installation of the refrigerator, go back
to Step 11 in Installing the Refrigerator.
36

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents