The Functions Of The Control Panel - Swann SW3010W Instruction Manual

THE FUNCTIONS OF THE CONTROL PANEL

Press this switch to turn the power on or off.
Operation and temporary stop is repeated as it is pressed.
When you want to change program in operating;
press the "Start/Pause" button → Select the program that you want to change → press the
"Start/Pause" button again.
You can select the cycle you want, and each lamp is turned on when that cycle is selected.
For the more detailed information, please refer to the page 11~18.
It can be used to adjust temperature of water according to types of the load to be washed.
As the button is pressed, temperature of water is selected by
Cold → 30˚C → 40˚C → 60˚C → 95˚C
By pressing the spin button, the spin speed can be chosen.
Rinse Hold
No spin
Spin only
Crease Care • If you want to prevent crease, select this button with spin speed.
Rinse+
Pre-Wash
All cycles have pre-set washing times, but Time Save decreases it by 10 minutes.
Each time this button is pressed the watch icon is repeated on and off. When it is on, the Time
Save function is set. Time Save is available in Cotton, Eco and Synthetic programs.
It can be used to pre-engage time for wash.
During an operation of washer, press 'Time Save' and 'Time Delay' buttons simultaneously.
In Child Lock mode, no button functions except Power button.
In Child Lock mode, press 'Time Save' and 'Time Delay' buttons simultaneously like setting Child
Lock and Child Lock is cancelled.
To change to the desird program, while in Child Lock mode;
1. Press both the Time save and Time delay buttons together once again.
2. Press the Start/Pause button.
3. Select the desired program and
* The Child Lock will be cancelled when power is off.
• Is selected by pressing the spin button repeatedly. This function leaves clothes
in the machine; suspended in the water after a rinse without entering into spin.
• To proceed through to a drain or spin, after the Rinse Hold function is
completed, use spin button.
• If no spin is selected, the washer stops after draining water.
•If you want only spin, you can operate spin only. (See page 18.)
• Is used to add a rinse, which may assist in removing traces of detergent residue.
• By selecting Rinse+ function, the rinse time and the rinse water are increased.
• The washer operates one additional wash and spin before the main wash.
• If the laundry is heavily soiled, Pre-Wash course is effective.
• Pre-Wash is available in Cotton and Synthetic programs.
press the Start/Pause button
again.
9
Change
the desired
program