Inlet Hose Connection; Electrical Safety - Swann SW3010W Instruction Manual

INLET HOSE CONNECTION

The washer should be connected to the water mains using new hose sets and old hose sets
should not be reused.
Connect the inlet hose to the cold water inlet valve.
1 Connect the inlet hose to
the water tap by screwing
the connector tightly.
Rubber
Connector
Packing
Hose Connector

ELECTRICAL SAFETY

THIS APPLIANCE MUST BE PLUGGED INTO AN EARTHED SOCKET.
Before switching on, make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate. This product is designed to operate on 220 – 240V AC; 50Hz.
Connection to any other power source may damage the unit.
This product may be fitted with a non – rewireable plug. If it is necessary to change the fuse in the
plug, the fuse cover must be refitted. If the fuse cover becomes lost or damaged, the plug must
not be used until a suitable replacement obtained.
If the plug has to be changed because it is not suitable for your socket, or becomes damaged in
any way, it should be cut off and an appropriate plug fitted following the wiring instructions below.
This should be carried out by a qualified electrician. The plug removed must be disposed of
safely, as insertion into a 13 Amp socket is likely to cause an electrical hazard.
2 Connect the connector-
inlet supplied if necessary.
Connector
inlet
Rubber
Connector
Packing
Hose Connector
5
3 Connect the inlet hose
adapter to the water inlet
of a washer and turn it to
be fixed.
*Check the packing in the inlet