Electrical Requirements - Swann SW3010W Instruction Manual

ELECTRICAL REQUIREMENTS

The wires in this mains lead are colored in accordance with the following code:
Blue = Neutral
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows (refer to the plug
wiring diagram).
GREEN
&
YELLOW
(Earth)
BLUE
(Neutral)
Drain system
• Never forget to install drain hose before operating your washer.
• Connect the drain hose to the drain outlet at the back side of the washer.
• Top of drain outlet must be at least 60cm high and no higher than 100cm from bottom of washer.
ca. 105cm
• When installing the drain hose to tub(sink), secure it tightly with a string.
• Proper securing of the drain hose will protect the floor from damage due to water leakage.
• When the drain hose is too long, do not force it back into the washer.
This will cause abnormal noise.
Level adjustment
1 If the washer is installed on an
unsuitable floor, it could make
considerable noise, vibrate and
cause a malfunction.
Wiring Instructions
Brown = Live
The wire which is colored BLUE must be connected to the
terminal which is marked with the letter N or colored Black.
The wire which is colored BROWN must be connected to
FUSE
the terminal which is marked with the letter L or colored
Red.
The wire which is coloured GREEN/YELLOW must be
connected to the terminal which is marked E.
If a 13Amp (BS1363) plug is used, a 13Amp (BS1362) fuse
BROWN
must be fitted, or if any other type of plug is used, a 13Amp
(Live)
fuse must be fitted, either in the plug or adaptor, or on the
Distribution Board.
6
Green/Yellow = Earth
Laundry tub
Hose
Retainer
Tie max. 100cm
min. 60cm
Strap
max. 100cm
min. 60cm