Setting The Camera Arm; How To Use; Turning Power On; Shooting The Material (Data - NEC DV11G User Manual

Setting the Camera Arm

As illustrated, raise the camera arm gently in the indicated direction while holding the
body down with your hand.
When the angle between the stage and the camera arm is 60 degrees, there is a click with
which the camera arm gets fixed momentarily. Normally use the equipment in this 60-
degree position. Though the camera arm may be raised to a position of 80 degrees, do
not attempt to raise it any further.
Be sure to hold the body down with your hand when raising
the camera arm.
Otherwise, the body may lift up to cause injury.

Turning Power On

Set the power switch on the back panel to ON ( ).
All the indicators on the control panel light up for about ten seconds.

Shooting the Material (Data)

q Place your material on the stage.
w Turn on the main light or turn on the base light, depend-
ing on the lighting in the room or the condition of the
material to be shot.
e Determine the size for the zoom shooting.
r Adjust the focus.
NOTE:
• For shooting a material with many characters, turn on the text mode, which will show the characters clearly for easier
reading.
CAUTION

How to Use

POWER
SWITCH
w
LIGHT
POSI/NEGA
BRIGHTNESS
RNAL AUTO
AUTO
E-14
(normal position)
WHITE BALANCE SOURCE
AUTO BLUE RED CAMERA
UP
MEMORY
DOWN
COLOR/BW TEXT/PHOTO
KEYSTONE
DARK BRIGHT ON/OFF
FOCUS
ZOOM
WIDE TELE
NEAR FAR
r e
60 degrees
MEMORY EXTERNAL
CAPTURE
REAL/FREEZE