Preparations Before Use; Connecting The Cable And Setting The Output Mode - NEC DV11G User Manual

Preparations before Use

Connecting the Cable and Setting the Output Mode

Connect the cable to the equipment that displays the image from this equipment. A selection can be made from
the RGB output and the video output. However, it is necessary to set the output method with the dip switch on the
back panel before turning on the power to this equipment.
For RGB output
Set the dip switch 4 to OFF.
Connect the RGB monitor output terminal 1 (RGB-OUT 1) to the RGB input terminal of a projector, display or
other image equipment.
1 2 3 4 5 6 7 8
1 2 3
With dip switch 5 set to ON, the same signal can be outputted from two systems by connecting a projector or
display to the RGB monitor output terminal 2 (RGB-OUT 2).
NOTE:
• In the case of RGB output only, the RGB output signals from a PC, for instance, may be outputted via this equipment.
For such an application, connect the RGB input terminal to the RGB output terminal on a PC or suchlike.
1 2 3 4 5 6 7 8
• With dip switch 5 set to OFF, the output signal from RGB monitor output terminal 2 is always the same as the signal of
the RGB input terminal.
When it is necessary to frequently switch between camera image and RGB signal, connect the display for PC control to
the RGB monitor output terminal 2 (RGB-OUT 2), then the PC can be controlled while watching the display even when
the camera image is on.
• The settings at dip switches 1 and 2 on the back of the equipment will not be reflected.
• Signals (display screen) inputted from the RGB input terminal of the equipment cannot be stored in memory.
Set dip switch 4 to OFF.
4 5 6 7 8
Commercially available RGB cable
Supplied RGB signal cable
To a display or projector
Set the resolution and fre-
quency of the output signal
of your PC or like device
according to the output
equipment, such as a dis-
play or projector.
E-12
Display
Projector
To PC or suchlike