Table of Contents
Advertisement
VIDEO MODE - ADVANCED OSD MENU
Part 4 - Available functions in VIDEO MODE Advanced OSD Menu:
This part explains all the functions available for more experienced users.
This part explains all the most common functions available which are required for most users.
Note that to be in VIDEO MODE, a video signal must be present in full screen, i.e from a camera, VCR or
DVD player.
- To acess this menu, press and hold the "DOWN" button while turning power on.
- On older BIOS Firmware below V1.2 you will have the advanced menu by default.
BRIGHTNESS AND CONTRAST:
Selecting this function will enable the user to adjust brightness and contrast
for the display.
BRIGHTNESS:
CONTRAST:
COLOR TEMPERATURE
Selecting this function will enable the user to modify the warmness of the picture.
Higher temperature = "cooler" picture. Lower temperature = "warmer" picture.
User can select between 9500K, 8000K, 6500K, and 5000K color temperature measured in
Kelvin degrees. Press "+" to access the sub-menu, where the RGB values can be adjusted.
Use "+" and "-" buttons to adjust these values, and "MENU" to exit. (Saving is done automatically)
VIDEO ADJUSTMENT:
Selecting this function will enable the user to modify the color saturation of the
picture, tint and sharpness.
COLOR:
TINT:
SHARPNESS:
PICTURE TYPE
VIDEO TYPE
Increase/decrease brightness level, total: 100 steps
Use "+" or "-" buttons to adjust values.
Increase/decrease contrast level, total: 100 steps
Use "+" or "-" buttons to adjust values.
:
Increase/decrease video color level.
Use "+" or "-" buttons to adjust values.
Increase/decrease tint level.
Use "+" or "-" buttons to adjust values.
Increase/decrease video image sharpness level.
Use "+" or "-" buttons to adjust values.
: Motion / Still (Adjustment for best image quality)
If graphics on screen move a lot, select "Motion"
If graphics on screen are mostly still, select "Still"
: Change to best match the source signal. (DVD / VCR)
16
Product:JH 23T01 MMD
Advertisement
Table of Contents
