Hughes BGAN Remote Antenna Installation Manual page 7

2. Carefully insert the strain relief adapter into the MCX connector of the terminal. Make sure the adapter is
well aligned with the terminal connector. Rotate the adapter such that the knob on the adapter points to
the knob on the housing as shown in figure 8c and the internal RF cable fits into the slot in the adapter.
Gently push the adapter down until it is flush with the terminal housing as shown in figure 8d. Don't
apply excessive pressure – try to realign the connector if the adapter does not slide in easily.
Figure 8d – Insert strain relief adapter flush with terminal housing
HUGHES is a registered trademark of Hughes Network Systems, LLC.
All other trademarks are the property of their respective owners.
© 2010 Hughes Network Systems, LLC. All rights reserved.
All information is subject to change.
Figure 8c – Alignment of strain relief adapter
Hughes Network Systems, LLC
11717 Exploration Lane Germantown, MD 20876 USA
bgan.hughes.com