Skew; Quick Test - Lexmark C540n Service Manual

Description Value

Skew

-100 to +100
Each increment corresponds to
1/1200 of an inch.
The default is 0.
6.
Print another copy of the Quick Test to verify your changes.
7.
Continue changing the settings by repeating steps 3 through 5.
To exit Registration, press Back (
Skew
One printhead houses the four color planes. The black plane is aligned to the printer, and the other color planes
are internally aligned to black. Electronic alignment fine tunes the alignment of the color planes to the black
plane once the printhead is installed. See
alignment. This must be performed before color skew adjustment is attempted. The following illustration shows
proper alignment versus skewed alignment.
Lexmark C544

Quick Test

Printer Information
Page Count xx
PSAC xx
Installed Memory xxx MB
Processor Speed xxxMHz
Serial Number xxxxxxx
CalStat xxxx
CalSet x.xx x.xx x.xx
x.xx x.xx
Engine ID xx
FSpeed xxx
Printer Rev isi on Lev els
Loader xx.xx.xxxx-x
Kernel xxx.xx.xxxx-x
Base xx.xx.xxxx-x
Network xxx.xx.xxxxx-x
Network Drvr xx.xx.xxxx-x
Engine xx.xx.xxxx-x
Font x.xxxxx-xx.x
Quick Test
The Quick Test contains the following information:
•
Print registration settings
•
Alignment diamonds at the left, right, top, and bottom
•
Horizontal lines to check for skew
)
or Stop ( ).
"Alignment" on page 3-7
Margin Settings
Top Margin = x
Bottom Margin = x
Left Margin = x
Right Margin = x
Skew = x
Cyan Top Margin = x
Cyan Left Margin = xx
Cyan Right Margin = x
Cyan Skew = x
Cyan Bow = x
Yellow Top Margin = x
Yellow Left Margin = x
Yellow Right Margin = x
Yellow Skew = x
Yellow Bow = x
Magenta Top Margin = x
Magenta Left Margin = x
Magenta Right Margin = x
Magent Skew = x
magenta Bow = x
Dup Top Margin = x
Paper Source = Tray 1
Formatted Size = xxxxxx
Straight
Direction of change
A positive value causes the left end of the scan
line to move down the page. A negative value
causes the left end of the scan line to move up
the page. The right end stays fixed. There is no
compression or expansion of the image.
for instructions on setting printhead
Skewed
5025-2xx, 4xx
3-5
Diagnostic aids