Lanzar SDBT75NU Owner's Manual page 8

INSTALLATION
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow
these mounting instructions.
Use the screw holes marked T (Toyota),
N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio
mounting brackets supplied with your
vehicle.
Side view showing
Screw Holes marked T, N
Factory Radio
Mounting
Bracket
Screw
To fasten the unit to the factory radio
mounting brackets.
1. Align the screw holes on the bracket
with the screw holes on the unit, and
then tighten the screws on each side.
2. Fasten with the supplied truss screws
(5x5mm) or flush surface screws
(4x5mm), depending on the shape of
the screw holes in the bracket.
Note:
(1) The outer trim ring, sleeve and the
metal strap are not used for method B
installation.
(2) When the unit is on work, if you release
the front panel, the unit will enter into the
power off state automatically, and you
can see the indicator LED flashing.
Screw
Dashboard or
Console
8
When you install the front panel the unit
will resume work automatically.