Code Search - GE Universal Remote Instruction Manual

Code Search
If your device does not respond after you have
tried all the codes for your brand, or if your brand is
not listed, try searching for your code by following
these steps.
1. Manually turn on the device (
be controlled.
2. Press and hold the
until the red indicator stays on, then
release the
3. Press and quickly release the desired
device button (
indicator blinks off once.
4. Press the
(up to 300 times) until the device
to be controlled turns off. The red
indicator blinks off with each button
press.
. Press and release
code.
Most users will store DVR codes under the DVR
button, Cable codes under CABLE, etc. If (for
example) you want to store a DVR code under
CABLE, first follow the procedure for Direct Code
Entry (previous page) and press CABLE in step 2
of Direct Code Entry, then enter ANY DVR code in
step 3 of Direct Code Entry. Then follow the steps
above for Code Search.
Note: Code Search starts from the currently
stored 4-digit number under that mode. Sometimes
the first code that "works" with your device may
only allow limited functionality (e.g., the MENU
button might not work). There may be a code
that performs more functions. Continue the code
search process until the best code is found.
SETUP
button.
SETUP
,
TV DVR
button repeatedly
ON-OFF
ENTER
,
TV
button
, etc.). The red
to install the
7
, etc.) to
DVR