Auto Code Search - GE 34455 Instruction Manual

Programming Your Remote, cont.

Auto Code Search

The Auto Code Search, searches automatically
through the codes stored in this remote. Read all the
steps prior to starting the auto code search as you
will need to be prepared to lock-in the proper code
when found.
1. Manually turn on the device you wish
2. Press and hold the SETUP button
3. Press and release the desired device
4. Point the remote at the device and
5. Place your fi nger on the #1 button so
6. When the device shuts off or begins
7. Point the remote at the device and
to control.
until the red indicator light stays on
(approximately 2 seconds) and then
release the button.
button on the remote (TV, DVD, CBL/
SAT, DVR/AUX) for the type of device
you wish to control. The red indicator
will blink once and then remain on.
press and release the POWER button
(for TV) or PLAY button (for DVD, VCR,
etc.) to start the search. The red
indicator will fl ash (approximately
every 2 seconds) as the remote
searches. Note: The remote must be
pointed at the device for the duration of
this search.
you are prepared to lock-in the code.
playing, press the #1 button to lock-in
the code. The red indicator light will
turn off. Note: You have approximately
two seconds after the device shuts off
or begins playing to lock-in the code.
check to see if the remote operates the
device as desired. If it does, no further
programming is required for that
device. If it does not, return to step 2
and start the auto code search again.
8