Align T-REX 450SA ARF Manual page 35

F) Aileron servo (front left) arm to outer swashplate, one required:
Rod Length
C to C Length
Overall Length
10.2 Install the completed linkages as shown in the following photos. Note, the side of the plastic ball link
marked with an "A" should be facing away from the control ball when installed properly. Also note
that some of the linkages may require one of the ball links to be adjusted perpendicular or slightly
angled to the other for proper alignment (this should already be the case if you have assembled the
linkages to the lengths previously listed, however, make any adjustments to the ball links for proper
alignment as necessary).
Note: When installing the elevator linkage on the outer swashplate, it is best to remove
the screw and control ball with anti-rotation post from the swashplate and anti-rotation
bracket first. You can then snap the link into place on the control ball with anti-rotation
post and re-install it through the anti-rotation bracket and onto the swashplate, with
the linkage in place.
19.0mm
32.3mm
37.8mm
35