Align T-REX 450SA ARF Manual page 28

7.1 After choosing a position for mounting the ESC, fasten it in place using double-sided servo tape and
cable/zip ties. Note that slots are located in the base plate to allow the cable/zip tie to neatly fasten
the ESC in position.
7.2 Secure the battery power input and motor power output wire leads exiting the ESC to prevent them
from coming into contact with any moving parts.
7.3 Connect the ESC's throttle channel servo lead to the throttle channel on your receiver. Be sure to
secure this lead so that it cannot come into contact with any moving parts.
7.4 Do not connect the ESC's motor power output wire leads/connectors to the motor at this time as it
will be necessary to set up the servos by using the ESC for power. This is only safe to accomplish with
the motor disconnected.
28