Table of Contents
Advertisement
1.5
Next, install the aileron servo inside the upper forward hole in the left-hand frame as shown. Note
that the output shaft of the servo must be oriented toward the rear of the helicopter. Use two screws
and two servo mounting plates to fasten the aileron servo in place.
1.6
The elevator servo mounts outside of the rear hole in the left-hand frame. The output shaft must be
facing inside the frame, oriented toward the rear of the helicopter. Note that the elevator servo's lead
must pass though the frame, in the notch provided just below the servo, before the servo is installed.
13
Hide quick links:
Advertisement
Table of Contents
