Table of Contents
Advertisement
Onboard
LAN1/LAN2/LAN3/LAN4
Control
On board FDC Controller
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
3.7 Power Management Setup
The "Power Management Setup" controls the CPU card's "Green" features. When you select
the "POWER MANAGEMENT SETUP" on the main program, the screen display will
appears as:
Power Management Setup Screen
ACPI Function : This item allows you to enable or disable the Advanced Configuration and
Power Management (ACPI). The settings are "Enabled" and "Disabled".
Power Management :
the name of the boot image. The client uses TFTP to download the
Network Bootstrap Program (NBP) from the Boot Server and then
initiates execution of the image (boots from the image).
Enable your LAN Controller
Enable the onboard floppy controller. Select Enabled when you have
installed a floppy disk drive.
Select an address and corresponding interrupt for the first and second
serial ports. The settings are "3F8/IRQ4", "2E8/IRQ3", "3E8/IRQ4",
"2F8/IRQ3", "Disabled", "Auto".
This item allows you to determine onboard parallel port controller I/O
address setting.
The settings are "378H/IRQ7", "278H/IRQ5",
"3BC/IRQ7", "Disabled".
Select an operating mode for the onboard parallel (printer) port. Select
"Normal", "Compatible", or "SPP" unless you are certain your hardware
and software both support one of the other available modes.
Select a DMA channel for the parallel port for use during ECP mode.
The settings are "3" and "1"
Advertisement
Table of Contents
