Table of Contents
Advertisement
Baud Rate
DRAM Clock
DRAM Timing Control
DRAM CAS Latency (2.5) Enables you to select the CAS latency time in HCLKs of 2/2 or 3/3. The
Bank Interleave
Precharge to Active
(3T/4T)
Active to Precharge
(6T/10T)
Active to CMD (3T)
DRAM DRAM Command
Rate (2T command)
Memory Hole At
15M-16M
System BIOS Cacheable
Video BIOS Cacheable
VGA Share Memory Size Select VGA memory size
You can choice Enable, Disable and Auto.
The Default baud rate is 38400.
This item enables you to manually set the DRAM Clock. We recommend
that you leave this item at the default value.
Set this By SPD to enable the system to automatically set the SDRAM
timing by SPD (Serial Presence Detect). SPD is an EEPROM chip on the
DIMM module that stores information about the memory chips it contains,
including size, speed, voltage, row and column addresses, and
manufacturer.
value is set at the factory depending on the DRAM installed. Do not change
the val-ues in this field unless you change specifications of the installed
DRAM or the installed CPU. The options are "2" and "2.5" default.
Enable this item to increase memory speed. When enabled, separate
memory banks are set for odd and even addresses and the next byte of
memory can be accessed while the current byte is being refreshed.
This item is used to designate the minimum Row Precharge time of the
SDRAM devices on the module.
This item specifies the number of clock cycles needed after a bank active
command before a precharge can occur.
This item specifies the minimum required delay between activation of
different rows.
This item enables you to specify the waiting time for the CPU to issue the
next command after issuing the command to the DDR memory. We
recommend that you leave this item at the default value.
You can reserve this area of system memory for ISA adapter ROM. When
this area is reserved, it cannot be cached. The user information of
peripherals that need to use this area of system memory usually discusses
their memory requirements.
Selecting "Enabled" allows caching of the system BIOS ROM at F0000h –
FFFFFh, resulting in better system performance. However, if any program
writes to this memory area, a system error may result. The settings are
"Enabled" and "Disabled".
Selecting Enabled allows caching of the video BIOS ROM at C0000h to
C7FFFh, resulting in better video performance. However, if any program
writes to this memory area, a system error may result.
Advertisement
Table of Contents
