Buffalo LinkStation LS210D0101 User Manual page 94

E23
E30
Amber
If there is a status message, the power LED will blink amber. The pattern of the blink gives the information code. You can
also see any status messages in NAS Navigator2.
Place
10s Place
1s Place
Information Code
I10
I11
I12
I13
I14
I15
I16
I17
I18
I19
I20
I21
I22
I23
I25
I26
I27
I28
I46
I47
I52
An error occurred, so the hard drive was
removed from the RAID array.
A hard drive error occurred.
Status
The LED flashes for 1.0 seconds every 0.3 seconds. This gives the tens place of
the information code.
The LED flashes for 0.5 seconds every 0.3 seconds. This gives the ones place of
the information code.
Description
A rise in system temperature may have
exceeded the allowable safety value.
The bad sectors in hard drive X may have
reached a dangerous level.
Operating in degraded mode.
Formatting RAID array X.
Checking RAID array X.
Examining the error status of RAID array X.
Note: Transfer speeds are slower during
the examination process.
Creating RAID array X.
Resynchronizing RAID array X.
Note: Transfer speeds are slower during
resynchronization.
Rebuilding RAID array X.
Note: Transfer speeds are slower during
the rebuilding process.
Writing 0s to RAID array X, erasing all data.
Formatting hard drive X.
Checking hard drive X.
Erasing the data for hard drive X.
System is being initialized.
Updating the LinkStation firmware.
Initializing all settings.
Checking USB hard drive.
Formatting USB hard drive.
Data migration or conversion (RAID
migration) is in progress.
Data migration or conversion (RAID
migration) is in progress.
A new firmware version has been
released.
Replace the faulty drive.
Replace the faulty drive.
Corrective Action
Move the LinkStation to a cool location.
Do not place objects in the area around
the LinkStation.
Replace hard drive X.
-
-
-
-
-
-
-
-
-
-
-
-
-
Don't turn off the LinkStation.
-
Don't turn off the LinkStation.
Don't turn off the LinkStation.
Don't turn off the LinkStation.
Update the firmware.
94