The data from the USB drive will be copied to the target folder. You may change the target folder from the drop-
down list if desired.
Configuration from a Computer
1
In Advanced Settings, move the Direct Copy switch to the
To change the Direct Copy target folder, navigate to Backup - Direct Copy - Edit, select a new folder, and click OK.
Starting Direct Copy
1
Connect the USB device. When it mounts (about 10 seconds), the function LED will light up.
Note: Devices that don't trigger the function LED to light up are not supported.
2
You now have 60 seconds to hold down the function button for 3 seconds. If you do, the function LED will flash as
all the files on the USB device are copied to the Direct Copy folder of the LinkStation.
Notes:
• While the function LED is flashing, hold the function button down for 3 seconds to cancel Direct Copy.
• For digital cameras that are not in the USB mass storage class, all files from the digital camera are copied.
3
When the copy operation is finished, the access LED of the USB device will stop flashing. Hold down the function
position to enable Direct Copy.
63