Installation Instructions; Tools And Materials Required; Electrical Requirements; Unpacking Your Dryer - Haier HLF11P User Manual

Electric dryer

Hide thumbs Also See for HLF11P:

Table of Contents

English

INSTALLATION INSTRUCTIONS

Select a suitable location for the dryer on a hard even surface away from direct

sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc.

Any floor unevenness should be corrected with the leveling legs located on the

bottom of the dryer.

• Phillips head and flathead screwdrivers

• Channel-lock adjustable pliers

1 /2

•

inch open end wrench

• Carpenter's level

• Measuring tape

• Duct tape

• Rigid or flexible metal 4 inch (10.2 cm) duct

Power Supply:

3 or 4 wire, 240 Volt, 30 Amp, 60Hz, 1 Phase

Power Supply Cord Kit: (not included)

The dryer MUST employ a 3-conductor power supply cord NEMA 10-30

type SRDT rated at 240 Volt AC minimum, 30 Amp., with 3 open end

spade lug connectors with upturned ends or closed loop connectors and

marked for use with clothes dryers. If being installed in a manufactured

(mobile) home, the dryer MUST employ a 4-conductor power supply cord

NEMA 14-30 type SRDT or ST (as required) rated at 240 Volt AC

minimum, 30 Amp., with 4 open end spade lug connectors with

upturned ends or closed loop connectors and marked for use with clothes

dryers. See Electrical Connections for a 4-Wire System.

1. Remove all packaging material. This includes the foam base and all

adhesive tape holding the dryer accessories inside and outside.

2. Inspect and remove any remains of packaging, tape or printed

materials before using the dryer.

Table of Contents