Setting The Rear Output And Subwoofer Controller; Switching The Telephone Muting/Attenuation - Pioneer DEH-P5750MP Operation Manual

Initial Settings
2 Press c or d to adjust the contrast.
Pressing c or d will switch between 1 and 2
and that status will be displayed.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put) can be used for full-range speaker
(Rear SP :FUL) or subwoofer (Rear SP :S/W)
connection. If you switch the rear output set-
ting to the Rear SP :S/W, you can connect a
rear speaker lead directly to a subwoofer with-
out using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :FUL). When rear out-
put is connected to full range speakers (when
Rear SP :FUL is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controllers (low pass filter, phase)
built-in Preout:S/W or the auxiliary
Preout:FUL.
1 Press FUNCTION to select Rear SP.
Press FUNCTION repeatedly until Rear SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
Rear SP :FUL (full-range speaker) and
Rear SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W.
# When the rear output setting is Rear SP :S/W,
you cannot change the subwoofer controller.
3 Press c or d to switch the subwoofer
output or non fading output.
Pressing c or d will switch between
Preout:S/W and Preout:FUL and that status
will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 35)
or subwoofer output (refer to Using subwoofer
output on page 34) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound is turned off, MUTE or ATT is
displayed and no audio adjustment is pos-
sible.
! Operation returns to normal when the
phone connection is ended.
1 Press FUNCTION to select Mute.
Press FUNCTION repeatedly until Mute ap-
pears in the display.
2 Press c or d to switch the telephone
muting/attenuation.
Pressing c or d will switch between
Mute:ATT (attenuation) and Mute:ON (mut-
ing) and that status will be displayed.
Section
09
39
En