Removing The Hall Sensor Board; Replacing The Hall Sensor Board - Dell Studio 14z Service Manual

Back to Contents Page
Hall Sensor Board
Dell™ Studio 14z Service Manual
Removing the Hall Sensor Board
Replacing the Hall Sensor Board
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
Removing the Hall Sensor Board
1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Remove the keyboard (see
4. Remove the hard drive (see
5. Remove the palm rest (see
1 hall sensor board cable
3 screw
6. Disconnect the hall sensor cable from the connector on the hall sensor board.
7. Remove the screw that secures the hall sensor board to the computer base.
8. Lift the hall sensor board out of the computer base.
Replacing the Hall Sensor Board
1. Follow the procedures in Before You
2. Place the hall sensor board on the computer base.
3. Connect the hall sensor cable to the connector on the hall sensor board.
4. Replace the screw that secures the hall sensor board to the computer base.
5. Replace the palm rest (see
6. Replace the hard drive (see
Begin.
Battery).
Removing the Keyboard).
Removing the Hard Drive).
Removing the Palm Rest).
2 hall sensor board
Begin.
Replacing the Palm Rest).
Replacing the Hard Drive).