How To Install Your Canopy Housing; How To Install The Light Bulbs - Fanimation The Beckwith FP7964 Series Owner's Manual

NOTE: This step is applicable after the neccessary wiring is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
Securely attach and tighten the canopy screw cover
2.
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 2)
1. Remove the preassembled screws and take off
the 4 light caps in the motor assembly. Retain the
screws and light caps for later. (Figure 1)
2. Install bulbs. (Figure 2)
3. Put the light caps back and securely tighten the
previously removed screws of light caps. (Figure 3)

How to Install Your Canopy Housing

WARNING

How to Install the Light Bulbs

11
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1
Figure 2
Figure 3
Motor
Assembly
Light
Cap
Bulb Bulb