Table of Contents
Advertisement
Connecting a DVD player with ColorStream® (component video), a VCR,
and a satellite receiver
Your TV has two sets of ColorStream® (component video) inputs.
TV lower back panel
AUDIO
OUT
G~:w:::lIl\.
~
.--- £>+-----1----.;=-----------......
I
f!S?J
l
~,I
PC IN
ANTJ5m~
~
y
Po
P,
IJl!oIi'f&
~
e~eW~
satellittl
COMPONENT VIDEO S-VIDEO VIDEO
IN
OUT
OUT
Satellite receiver with component video
From satellite dish
DVD
player wilh component video
'&P,&P'
e
~
COMPONENT VIDEO $-VIOEO VIDEO
OUT
OUT
You will need:
• coaxial cables
• standard AN cables
- For better picture performance, if your VCR has S-video,
use an S-video cable (plus the audio cables) instead of
the standard video cable. Do not connect both types of
video cable to VIDEO 1 at the same time or the picture
performance will be unacceptable.
- If you have
a
mono VCR, connect UMONO on the TV to
your VCR's audio out terminal using the white audio cable
only.
• standard audio cables
• component video cables
- You can connect the component video cables (plus audio
cables) from the OVO player or satellite receiver to either
set of ColorStream terminals on the TV (HD-1 or HD-2).
The ColorStream HD-1 and HD-2 terminals can be used
with Progressive (480p, 720p) and Interlaced (480i, 1080i)
scan systems. A 1080i signal will provide the best picture
performance (1080p is not supported).
- If your OVO player or satellite receiver does not have
component video, connect
a
standard AN cable to
VIDEO
2
on the side panel. If your OVO player has HoMI
video, see page 20.
To view satellite programs using the component video
connections:
Turn on the satellite receiver. Select the ColorStream HD-2
video input source on the TV. *
To view the VCR or view and record antenna
channels:
Turn ON the VCR. Tune the VCR to the channel you want to
watch. Select the VIDEO 1 video input source on the TV. *
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to record.
Select the ColorStream HD-1 video input source on the TV*
to view the DVD.
*
To select the video input source. press
INPUT
on the remote control
(B"
page 24). To program the TV remote control to operate other
devices. see Chapter 3
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Laws of the United States and
other countries, and may subject you to civil and criminal
liability.
To view antenna or Cable channels:
Select the
ANT
video input source on the TV. *
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD-1
video input source on the TV. *
I
18
Advertisement
Table of Contents
