Table of Contents
Advertisement
Section 2: Options, Assembly & Set-Up
Section 2: Options, Assembly & Set-Up
Blade Offset Cylinder
Refer to Figure 2-1:
IMPORTANT: Do not remove shipping block from
the blade tilt housing until all cylinders and/or ratchet
jack and manual links have been installed.
IMPORTANT: Attach cylinder base to the front hitch
lug. The cylinder base will interfere with the main
frame if attached to the rear lug.
Assemble the hydraulic hoses to the hydraulic cylinder
before placing the cylinder on the blade.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two straight fittings (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 116" long hydraulic hoses (#5) into
straight fittings (#4) and tighten.
3. Thread adapter fittings (#6) to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder to the lugs located on the
left side of the 3-Way Rear Blade with clevis pins
(#2). Make sure hydraulic ports are positioned on top
and the cylinder base in positioned to the front as
shown.
5. Secure clevis pins with hair pin cotters (#1).
6. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to
tractor's hydraulic system.
25502
Hydraulic Blade Offsetting
Figure 2-1
10
RBT55120 Rear Blades 301-172M
Table of Contents
Blade Angling Cylinder
Refer to Figure 2-2:
IMPORTANT: Do not remove shipping block from
the blade tilt housing until all cylinders and/or ratchet
jack and manual links have been installed.
IMPORTANT: Attach cylinder base to the front hitch
lug. If attached to the rear lug, the base will interfere
with the main frame.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two straight fittings (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 116" long hydraulic hoses (#5) into
straight fittings (#4) and tighten.
3. Thread adapter fittings (#6) to the other end of the
hydraulic hoses and tighten. (Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder to the lugs on the right side
of the frame with clevis pins (#1). Make sure
hydraulic ports are positioned on top and the cylinder
base in positioned to the front as shown.
5. Secure clevis pins with hair pin cotters (#2).
6. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to
tractor's hydraulic system.
25503
Hydraulic Blade Angling
Figure 2-2
Land Pride
5/21/07
Advertisement
Table of Contents
