Manual Gauge Wheel Adjustment; Gauge Wheel; Hydraulic Gauge Wheel Adjustment - Land Pride REAR BLADES RBT55120 Operator's Manual

Land pride rear blades operator's manual

Hide thumbs Also See for REAR BLADES RBT55120:

Table of Contents

Land Pride

Section 3: Adjustments

Refer to Figure 2-3 on page 11:

The blade end can be tilted hydraulically with the tilt

cylinder by as much as 30 degrees.

1. If the tilting cylinder is attached to the selector valve,

make certain the valve lever is set to operate that

cylinder.

2. Operate tractor control lever to change blade tilt by

as much as 30 degrees.

Refer to Figure 2-5 on page 13:

The gauge wheel provides accurate depth control when

grading, leveling or terracing. The height of the gauge

wheel is determined by adjusting the ratchet jack or

hydraulic cylinder.

IMPORTANT: The top center 3-point link can be

removed from both the blade and tractor before

using the gauge wheel accessory with the blade.

Manual Gauge Wheel Adjustment

1. Set ratchet lock and pump lever back and forth to

raise the gauge wheel.

2. Reposition ratchet lock and pump lever back and

forth to lower gauge wheel.

1. If the gauge wheel cylinder is attached to the selector

valve, make certain the valve lever is set to operate

that cylinder.

2. Operate tractor control lever to change gauge wheel

height up or down.

5/21/07

Table of Contents

RBT55120 Rear Blades 301-172M

Table of Contents