Squelch Setting - Vertex Standard VX-510 Operating Manual

VX-510 O M
PERATING ANUAL
R S S
ECEIVER QUELCH ETTING
The squelch setting on your VX-510 is preset at the factory, and does not
normally require re-adjustment. However, in the event that this should
become necessary:
To adjust the squelch, use the Allen wrench to loosen the setscrew secur-
ing the VOL knob, then pull off the VOL knob. Rotate the small brass
collar just above the base of the VOL control shaft, using a pair of twee-
zers, as shown below. Be careful not to loosen the larger mounting nut at
the base of the control. When done, rotate the VOL control shaft fully to
the counter-clockwise position (into the click-stop), and press the VOL
control back on the shaft to align the indicator of the VOL control to the
dot "  " on the top panel, then tighten the setscrew.
Adjustment of this control affects whether your radio can hear distant and
nearby stations, or only nearby ones; therefore we recommend leaving the
control as set, or having your Yaesu dealer perform the adjustment.
16