Voltage Selector Switch - Pioneer A-107 Operation Instructions Manual

Information to User
Alteration or modifications carried out without appropri-
ate authorization may invalidate the user's right to oper-
ate the equipment.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit or electric
shock. Do not place the unit, a piece of furniture, etc., on the
power cord, or pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords should be routed
such that they are not likely to be stepped on. A damaged
power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it
damaged, ask your nearest PIONEER authorized service
center or your dealer for a replacement.
MAINTENANCE OF EXTERNAL SURFACES
÷ Use a polishing cloth or dry cloth to wipe off dust and
dirt.
÷ When the surfaces are very dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and wrung out well, and then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
÷ Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit, since these will corrode
the surfaces.
2
<ARB7137>

VOLTAGE SELECTOR SWITCH

Only multi-voltage model is provided with this switch.
U.K., European, Australian and New Zealand models are
not provided with this switch.
Main voltages in Saudi Arabia are 127 V and 220 V only.
Never use this model with 110 V setting in Saudi Arabia.
The line voltage selector switch is on the rear panel. Check
that it is set properly before plugging the power cord into the
AC outlet. If the voltage is not properly set or if you move to
an area where the voltage requirements differ, adjust the
selector switch as follows.
1. Disconnect the power cord.
2. Use medium-size screwdriver.
3. Insert the screwdriver into the groove on the voltage
selector and adjust so that the tip of the arrow points to the
voltage value of your area.
220V
110V
240V
120-127V