Voltage Selector - Pioneer A-447 Operating Instructions Manual

PANEL FACILITIES
@2 TREBLE tone control
Use to adjust the high-frequency tone. The center position is the flat
(normal) position. When turned to the right, high-frequency tones are
emphasized; when turned to the left, high-frequency tones are de-
emphasized.
NOTE:
¢ This control does not operate when DIRECT switch is in the on
position.
® At volume levels lower than "4", the set tone control effect is
obtained.
At volume levels higher than "'4"', the effect becomes increasingly
weaker.
[REAR PANEL]
(3 BASS tone control
Use to adjust the low-frequency tone. The center position is the flat
(normal) position. When turned to the right, low-frequency tones are
emphasized; when turned to the left, low-frequency tones are de-
emphasized.
NOTE:
¢ This control does not operate when DIRECT switch is in the on
position.
© At volume levels lower than "4", the set tone control effect is
obtained.
At volume levels higher than 4", the effect becomes increasingly
weaker.
PHONES jack
When using headphones, insert the plug into this jack. -
1N
ah
OLI@OlLO O©!O ©O
(5) PHONO terminals
@é) ADAPTOR OUT terminals
(@) ADAPTOR IN terminals
LINE terminals
DAT/TAPE 1 REC terminals
DAT/TAPE 1 PLAY terminals
@) SPEAKERS B terminals (right channel)
@) SPEAKERS B terminals (left channel)
@) Power cord
Connect this cord to an AC wall socket, or the AC outlet of an audio
timer.
'Switched UNSWITCHED
TOTAL 200W MAX 100W MAX
VOLTAGE SELECTOR:
120-27V NOV
@ SPEAKERS A terminals (left channel)
@ SPEAKERS A terminals (right channel)
@) TAPE 2 PLAY terminals
@ TAPE 2 REC 'fenianals
CD terminals
TUNER terminals
@Q Turntable ground terminal (GND)
@) Shorting bars
@ AC OUTLETS
@ VOLTAGE SELECTOR
(multi-voltage models)
5
<ARE1161>
En