Vfp20In Log Placement - Empire Comfort Systems VFP20IN3 series Owner's Manual

Before you begin: Do not, handle these logs with your
bare hands! Always wear gloves to prevent skin irritation.
After handling logs, wash your hands gently with soap and
water.
All Logs
The positioning of the logs is critical to the safe and clean
operation of this heater. Sooting and other problems may
result if the logs are not properly and firmly positioned in the
appliance.
Warning: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property
damage or personal injury.
PROPER INSTALLATION SEQUENCE:
(Figure 26)
1. Place back (#1) log between rear log support and burner
pan.
2. Place left, front log (#2) onto two (2) left, front pins on
burner pan.
3. Place right, front log (#3) onto two (2) right, front pins on
burner pan.
4. Compare the completed log installation with the
appropriate photo from page 47. Review previous steps
to make any necessary adjustments.
5. Log placement is completed.
6. Attach log placement plate to cable holding lighting
instructions for future reference.
Attention: Do not use Figure 26 to order replacement logs.
Refer to Page 46 Parts List and Parts View to order logs for
your appropriate model number.
Apply loose material (glowing embers) per appropriate
Installation Instructions and Owner's Manual. Replacement
of loose material (glowing embers) must be purchased from
an authorized distributor. Application of excess loose material
(glowing embers) may adversely affect performance of the
heater.
Rock wool can be added to burners for a glowing ember
effect. Apply loose material (glowing embers) only on
locations shown on Page 25. Replacement of loose material
(glowing embers) must be purchased from Empire Comfort
Systems, Inc. Application of excess loose material (glowing
embers) may adversely affect performance of the heater.
Page 24

VFP20IN LOG PLACEMENT

WARNING: All previously applied loose material must be
removed prior to reapplication.
Replacement Loose Material (glowing embers)
Part Number: 15998
Note: A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with
production embers) to the burner.
1
2
Log Placement
Figure 26
The following WARNING applies when log set is installed
onto an unvented gas burner assembly.
WARNING: This appliance is equipped for (natural or
propane) gas. Field conversion is not permitted.
3
29829-14-1114