Table of Contents
Advertisement
Explanation of functions
Factory settings
Encoding switch factory setting
1. Lower position
Alarm signal function ON.
2. Lower position
Driver controller.
3. Lower position
Roller shutter / awning mode.
Explanation of functions
Manual/Automatic sliding switch
In the "MANUAL
" mode, only manual control commands and
alarm signals are executed (e.g.: by pressing UP, STOP, DOWN
buttons and alarm button).
When the sliding switch is set to "AUTO", automatic control
commands are carried out (e.g. control signals via group control
inputs.).
Alarm signal control light
An alarm signal is a continuous switching signal at the group or
individual control inputs which lasts for more than 5 seconds.
If the alarm signal control light is illuminated, this indicates an
alarm signal. The encoding switch 1 can be used to switch the alarm
signal function on or off.
GB-7
Explanation of functions
Reset button:
Press the Reset button (with a ballpoint pen or similar object) to
delete the intermediate position and the ventilation/reverse
position.
POS B:
The Pos B button can be used to programme an intermediate posi-
tion.
POS V:
The Pos V button can be used to programme a ventilation/reverse
position.
Group control:
Group control refers to the simultaneous operation of several drives.
Intermediate position:
The intermediate position lies between the upper and lower limits
of the roller shutters/ sun protection system and can be freely
selected. The roller shutters/sun protection system can be moved
into this position from the upper end limit after programming.
To do so, press the DOWN button twice in quick succession.
When the system is in venetian blind mode, it is also possible to
programme a reverse position. In this case, this command will be
automatically executed following the intermediate position
command.
Ventilation/reverse:
The ventilation/reverse position lies between the upper and lower
limits of the roller shutters/ sun protection system and can be free-
ly selected. Your roller shutters can be moved into this position
from the lower end limit until the ventilation slats are open.
In venetian blind mode, the blind slats are turned.
To do so, press the UP button twice in quick succession.
GB-8
Advertisement
Table of Contents
