Aastra 6753 User Manual page 57

Installation of the terminals in the range
Wall mounting
Installing the handset cradle
On a wall-mounted phone, the handset is held by a stud that has to be pulled out of the
housing:
1 - Use a pointed and rigid instrument to pull the stud fully out of its slot, which is located
on the side where the earpiece of the handset is placed.
2 - Turn the stud round and re-insert it into its slot with a slight pressure. The stud must now
protrude from its slot, so that the handset can be hung on it.
Fixing the phone on the wall
The phone has two pre-drilled holes on the back of the housing for wall-mounting. Mark on
the wall the location of the drill holes for the mounting screws. Depending on the quality of
the wall, wall anchors may be required. The screws and wall anchors are included in the
delivery.
Place the wall mounting holes of the phone above the heads of the screws in the wall, then
pull down to fasten the phone.
56
1
2
3
3 locations on
the base to customise
the tilt of the phone