Blower, Pulley And Pulley Cover Assembly - Land Pride Accuz Z52 , Z60, Z72 Operator's Manual

Section 1 Assembly and Set-Up

Blower, Pulley and Pulley Cover Assembly

Refer to Figure 1-7:
1. Install double pulley (#13) with the bolt (#11) and
existing flat washer (#12) Torque bolt 65 - 75 lbs.
2. Reinstall blade drive belt on lower grove of pulley
(13).
3. Assemble bracket (#4) where the chute bracket was
assembled using the existing hardware (#2) and
(#3).
4. Assemble blower pivot (#5) with carriage bolt (#6)
and existing hardware (#7), (#8), (#9) and (#10).
5. Install blower (#1) on blower pivot and swing blower
around and secure to bracket with pin (#14) and hair
pin cotter (#15).
Blower Assembly
Figure 1-7
10 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
6. Install blower belt (#16) to double pulley and route it
as shown. (Belt must be on top pulley)
7. Assemble pulley cover (#17) using existing knobs
(#18).
Route Belt to
Top Pulley
Blower
Drive Belt
20855
Blower Belt
Land Pride
03/11/03